Left Continue shopping
Your Order

You have no items in your cart

Free Shipping US Orders $99+


KBDfans Stabilizer Foam Stickers

30 reviews
Pack of 20

KBDfans Stabilizer Foam Stickers effectively reduce the noise caused by the stabilizer making contact with the PCB. It is also compatible for both screw-in and plate mount stabilizers.

KBDfans Stabilizer Foam Stickers Feature:

  • Combination of foam and elastic material
  • Installation steps:
    • Apply foam sticker onto the PCB
    • Install stabilizer to the PCB


  • 20 KBDfans Stabilizer Foam Stickers


Customer Reviews
4.8 Based on 30 Reviews
5 ★
4 ★
3 ★
2 ★
1 ★
Write a Review Ask a Question

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
Alejandro P.
United States United States

Great Material, Cheaper Shipping

They're pretty much what you'd expect and they're really great, but buying them from Divinikey saves you the $20 shipping you'd have to buy with KBDFans, so definitely suggest buying from here instead!

Ron A.
United States United States

Hate band-aid modding? Buy this!

I bought this for all my boards. It softens the bottom out on the stabs. In addition it's all pre-cut ready to go! SECRET TIP: Use the left over strips in between the cut outs to Holee mod your stabs. They're the perfect width!

Jonathan A.
United States United States

Totally worth the money

I hate cutting cutting the bandaids and the material feels more quality than the bandaids. Took me a while to realize that the hole cutouts are different sizes. One end is a larger hole than the others (which fits the need)

Rita R.
United States United States

About as cheap as bandaids

These offer a decent amount of sound dampening despite being thin, you can take a screw driver and lightly tap it against the raw PCB, and then against one of these when install and you'll notice an instant difference in level of sound. In some cases, where you're just replacing plate mounted stabalizers one side end of the foam (screw tab) might be facing upwards attached to the foam gasket between the PCB and Plate, but it doesn't cause any problems. You'll need a pair of tweezers to really get them aligned, its not painful or difficult, just a little easier than without. This is only a thing if you have plate mount and don't take apart the entire board. I installed these and tested them before I lubed my switches and they bottom out with more bass, since they are being cushioned. I might try doubling up on my space bar, as I still think the bottom out is a bit too loud, and these are thin enough that there shouldn't be any interference. You get 20 in a box, so unless you have all full sized stabs on a full sized KB you should have plenty to experiment with. I only lost 1, due to a bit of scrunching up during removal. I bought 2 packs just in case, but it was unnecessary. I put a tiny amount of lube so on them, and it didn't affect anything or make things tacky.

Christopher J.
United States United States

Nice PCB pad

they're really nice and fit well with the PCB mount stabs that I was using. They're nice.