I am very pleased with basically everything about this keyboard stand. The friction fit tolerances with the horizontal piece are spot on. It comes with 8 circular bumpons so that the stand doesn't slide around and it holds keyboards nicely. Note it may not work as perfectly with Arisu/Alice keyboards, but basically everything else will work nicely.
I was considering a number of options for displaying my keyboards, but it seemed like all of the budget options weren’t intended to protect the edges and finish of the keebs. I stumbled upon this stand whilst shopping for some switches, and I ordered two of them to try out. This stand works perfectly, it was super easy to assemble - and I enjoy the simplicity and low profile of it. A lot of stands I’ve tried tend to stand out in my setup and look like an eyesore. This one fits seamlessly into my setup and makes my keyboards the center of attention. A concern of mine was that with it being 3D printed, it might be flimsy or abrasive. I can assure you, this is not the case. The stands have a very sturdy feel to them, and a smooth to the touch surface. The included pads sit right under the contact points of the keyboard and not only keep it snugly seated but also protect the finish. I plan on ordering more!
It's pretty good for what it is
I have since replaced this on my desk for the Geon stand but I think this is works well. I now use this to hold a board when I'm building a different board or to hold the case while I have a board disassembled. My only gripe is that it can and on occasion does separate and that make me feel a bit iffy about it holding "my precious" keyboard. It's has never come apart while holding a board or anything. I think that for my peace of mind this is better suited for holding boards on a shelf or some other location where they're more or less being stored and that wasn't my use case. Otherwise it's been great. Goes together easy and comes with everything (except instructions lol). I still would recommend it and it won't scratch up your keyboard.
I bought six of these and I gotta say, they're wonderful. I'm using them with a range of boards, from 65% to Arisu to 1800, and they work perfectly with all of those layouts. Simple to assemble, durable, and stealthy black.